Float control: Place both the draft control lever and the position control lever in the float position to make the lower links move freely along with the ground conditions.Going too deep and causing loss of traction and ground speed. Although it won't help you with bushhoging, it can have the desired effect you describe when using a ground engaging implement. Point where the implement is at the desired depth. Draft control can work by sensing the pulling on either the top link or the lower links, depending on the tractor model, and its sensitivity is usually adjustable on modern tractors. To limit the degree, the implement can be lowered, set the position control lever at the lowest working depth desired for the implement. However, the implement sometimes lowers too much. Mixed control: In draft control, when draft decreases, the implement automatically lowers to increase draft. Draft control is the ability for a tractor to adjust the depth of its three-point hitch based on soil conditions and engine power output.It works good in the ag tractor. Place the position control lever in the lowest position and set the implement pull with the draft control lever. 12170 I have draft control in the 33 hp Yanmar and also in the ag tractor. As the load on the 3-point hitch changes due to various soil conditions, the draft control system automatically responds to these changes by either raising or lowering the implement slightly to maintain a constant pull. Draft control: This will control the pull of the 3-point implement.Position control :This will control the working depth of 3-point hitch mounted implement regardless of the amount of pull required.
0 Comments
Leave a Reply. |